Cisco Headend System Release 2.7 Installation Guide
Verify the Number of BFS Sessions
4042225 Rev A
93
Session 10: 00:00:00:00:00:02/20
Session 11: 00:00:00:00:00:02/22
Session 12: 00:00:00:00:00:02/199
7 In the dncs xterm window, type the following command and press Enter. The
number of Active Streams on the ASI card is displayed.
/opt/solHmux64/vpStatus –d /dev/Hmux0 –P 0
Example: /opt/solHmux64/vpStatus -d /dev/Hmux0 -P 0
STATUS: /dev/Hmux0
PORT: 0
MAX BANDWIDTH: 38800000
REMAINING BANDWIDTH: 25800000
TRANSPORT ID: 110
PSI INTERVAL: 80
OPTION SETTINGS:
188 byte packets
Automatic PSI table generation turned ON
ACTIVE STREAMS: 12
ACTIVE TABLE STREAM IDs: 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0
8 Do the number of sessions match the number of pre-upgrade sesssions?
If yes, continue with Reset the Modulators (on page 96).
If no, execute the procedures in Tear Down BFS and OSM Sessions (on page
93).
93).
Tear Down BFS and OSM Sessions
Complete this procedure ONLY if the number of recovered BFS sessions does not
match the number of pre-upgrade BFS sessions. Complete these steps to tear down
the BFS and OSM sessions in order to return the BFS session count to the expected
number of sessions.
1 Open the Digital Network Control System WebUI.
2
match the number of pre-upgrade BFS sessions. Complete these steps to tear down
the BFS and OSM sessions in order to return the BFS session count to the expected
number of sessions.
1 Open the Digital Network Control System WebUI.
2
Click Process Status. The Process Status page appears.
3 Click DNCS. The DNCS Process Status page appears.
4 Click bfsServer on the left side of the page.
5 Click Stop at the bottom of the page. The bfsServer process stops and turns red.
6 Click osm on the left side of the page.
7 Click Stop at the bottom of the page. The osm process stops and turns red.
8 Click DNCS in the top left corner of the page. The Digital Network Control
4 Click bfsServer on the left side of the page.
5 Click Stop at the bottom of the page. The bfsServer process stops and turns red.
6 Click osm on the left side of the page.
7 Click Stop at the bottom of the page. The osm process stops and turns red.
8 Click DNCS in the top left corner of the page. The Digital Network Control
System page appears.
9 Click Utilities. The Application Tools page appears.
10 Click Session List. The Session List Filter page appears.
11 Select the BFS QAM from the QAMs list.
10 Click Session List. The Session List Filter page appears.
11 Select the BFS QAM from the QAMs list.