Cisco Headend System Release 2.7 Installation Guide
Verify the Number of BFS Sessions
4042225 Rev A
95
29 In the dncs xterm window type the following command and press Enter. The
BFS session count is displayed.
auditQam –query [BFS QAM IP address] 2
Example: auditQam –query 172.16.4.20 2
Important: Be sure to use the IP address of the BFS QAM in your system when
running this procedure.
Important: Be sure to use the IP address of the BFS QAM in your system when
running this procedure.
Number of Sessions = 12
Session 1: 00:00:00:00:00:02/2
Session 2: 00:00:00:00:00:02/4
Session 3: 00:00:00:00:00:02/6
Session 4: 00:00:00:00:00:02/8
Session 5: 00:00:00:00:00:02/10
Session 6: 00:00:00:00:00:02/12
Session 7: 00:00:00:00:00:02/14
Session 8: 00:00:00:00:00:02/16
Session 9: 00:00:00:00:00:02/18
Session 10: 00:00:00:00:00:02/20
Session 11: 00:00:00:00:00:02/22
Session 12: 00:00:00:00:00:02/199
30 Does the Session Count total equal the number of sessions you recorded in the
Check the Number of BFS Sessions (on page 22) procedure?
If yes, continue with step 31.
If no, contact Cisco Services for assistance.
31 In the dncs xterm window, type the following command and press Enter. The
number of Active Streams on the ASI card is displayed.
/opt/solHmux64/vpStatus –d /dev/Hmux0 –P 0
Example: /opt/solHmux64/vpStatus -d /dev/Hmux0 -P 0
STATUS: /dev/Hmux0
PORT: 0
MAX BANDWIDTH: 38800000
REMAINING BANDWIDTH: 25800000
TRANSPORT ID: 110
PSI INTERVAL: 80
OPTION SETTINGS:
188 byte packets
Automatic PSI table generation turned ON
ACTIVE STREAMS: 12
ACTIVE TABLE STREAM IDs: 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0
0 0 0 0 0 0 0 0
32 Does the number of Active Streams match the output from step 31?
If yes, go to the next procedure in this chapter.
If no, contact Cisco Services for assistance.