Cisco DNCS System Release 2.7 3.7 4.2 Installation Guide

Page of 124
 
 
 
Run fixSiteConfigs on the RNCS EC 
 
OL-31613-01 
45 
 
Run fixSiteConfigs on the RNCS EC 
Only perform this procedure if the site you are upgrading includes an RNCS EC 
system. If the site you are upgrading does not have an RNCS EC, skip this procedure 
and go to the next procedure in this chapter. 
This procedure fixes the /tftpboot config files for headend components. It also sets 
the AlarmServerIpAddr entries to the correct IP address for the RNCS EC. 
1  As root user on the RNCS EC, type the following command and press Enter
fixSiteConfigs
 
Sample output: 
# fixSiteConfigs
 
     fixSiteConfigs: Fixing config files in 
lionn1:/tftpboot...
 
     fixSiteConfigs: modified: goqam.config
 
     fixSiteConfigs: modified: gqam.config
 
     fixSiteConfigs: Ignoring platform file 'inet-config'
 
    fixSiteConfigs: modified: mqam.config
 
     fixSiteConfigs: WARNING: unknown tftpboot config file: 
'nc.config'
 
    fixSiteConfigs: no mods needed: nc.config
 
     fixSiteConfigs: modified: qam.config
 
     fixSiteConfigs: modified: qpsk.config
 
     fixSiteConfigs: modified: scsmqam.config
 
     fixSiteConfigs: 6 of 9 tftpboot config files were 
modified
 
2  Type the following command and press Enter
cd /tftpboot
 
3  Verify that each of the .config files contains the correct IP addresses. 
Notes: 
 
The QAM config files contain two IpAddr variables, RpcServerIpAddr and 
AlarmServerIpAddr. These entries should have the following IP addresses 
assigned: 
RpcServerIpAddr = [dncsatm IP Address]
 
AlarmServerIpAddr = [RNCS IP Address]
 
 
If these variables do NOT have the correct IP address assigned, contact Cisco 
Services for assistance. 
 
Ignore any inet-config and nc.config warnings. 
 
downloadlike
ArtboardArtboardArtboard