Cisco Cisco StadiumVision Mobile Streamer Maintenance Manual
© 2011
−2015 Cisco Systems, Inc. All rights reserved.
5 of 27
The Checked At column in the Device List displays the progress of a command on a
per device basis. Once the command has completed, a timestamp of when the
command completed will be displayed.
per device basis. Once the command has completed, a timestamp of when the
command completed will be displayed.
You cannot send some commands on a DMP in the Factory Default/Not
Ready state. After initial installation of a Cisco DMP 4310G, use the Initial
Config command (Cisco DMP 4310G only) to move the DMP to the Ready
state. See “Deploying the Initial Configuration” in the
Ready state. After initial installation of a Cisco DMP 4310G, use the Initial
Config command (Cisco DMP 4310G only) to move the DMP to the Ready
state. See “Deploying the Initial Configuration” in the
Making Changes to Command Parameters
Some commands have user-specified parameters that you can set as described
here.
here.
Parameters that are common between DMP models are sent to all models.
Be sure to enter parameters specific to a DMP type in the correct tab.
Be sure to enter parameters specific to a DMP type in the correct tab.
1. Select a command. A description of the command and the command parameters
box displays in the Dashboard Drawers panel.
2. In the Command Parameters box, select the appropriate tab for the DMP type.
• Legacy releases─Tabs are Common, 4305 Parameters, or 4310
Parameters.
• Release 4.0─Tabs are Common, 4310 Parameters, or SV-4K Parameters.
3. Type the desired value for the parameter name.
4. Click the Play button in the Device List to send the command.