Cisco Cisco StadiumVision Mobile Streamer Maintenance Manual
© 2011 Cisco Systems, Inc. All rights reserved.
Page 33 of 40
Ready: The DMP is provisioned in SV Director but has not been assigned to a
Location. Note that all scripting is done on Locations and not on DMPs.
In Production: The DMP is registered, provisioned and assigned to a Location
in SV Director.
As the DMP transitions through these states, you can view the progress on the
Management Dashboard and Control Panel.
Management Dashboard and Control Panel.
Table 4 lists the Provision DMP command sequence. If any step fails, the overall
Provision DMP operation fails.
Provision DMP operation fails.
Refer to the StadiumVision Video Endpoints Design and Implementation Guide for
more details about auto registering and provisioning a DMP.
more details about auto registering and provisioning a DMP.
Table 4.
Provision DMP Command Sequence
Order
Command
Description
1
GetStatus
Retrieves the current settings on the DMP
2
StateTransition
Changes the DMP State to 'Not Ready'
3
InitialConfig
Executes the InitialConfig command on the DMP. This command sets the
credentials in the DMP and is executed only if the DMP is in the Factory Default
state. The DMP is rebooted as part of this command execution. A subsequent
DMP registration message will trigger the Workflow to advance to the next step.
credentials in the DMP and is executed only if the DMP is in the Factory Default
state. The DMP is rebooted as part of this command execution. A subsequent
DMP registration message will trigger the Workflow to advance to the next step.
4
GetStatus
Retrieves the most current configuration on the DMP. The GetStatus command
is executed at various points of the Provision DMP workflow and is intended to
refresh the DMP state in SV Director so that the execution of previous workflow
steps are reflected correctly in the SV Director Database.
is executed at various points of the Provision DMP workflow and is intended to
refresh the DMP state in SV Director so that the execution of previous workflow
steps are reflected correctly in the SV Director Database.
5
Firmware
Upgrade
Upgrade
The SV Director will upgrade the firmware on the DMP, if required. A DMP
reboot will trigger the workflow to advance to the next step.
reboot will trigger the workflow to advance to the next step.
6
GlobalMIB
Deploys the Global DMP Settings on the DMP. This step is performed only if the
device is not conforming with the current Global DMP Settings
device is not conforming with the current Global DMP Settings
7
GetStatus
Retrieves the most current configuration on the device. Note that a previously
executed Firmware Upgrade would have changed the version and build strings
to match the currently running firmware on the DMP
executed Firmware Upgrade would have changed the version and build strings
to match the currently running firmware on the DMP
8
StageTemplate
The Flash Template is staged on the DMP.
9
GetStatus
Retrieves the current configuration from the DMP and saves in the SV Director
Database
Database
10
StateTransition
Sets the DMP State to Ready
11
GetStatus
This final GetStatus is issued to get the most current DMP configuration. It is not
necessary to issue this final GetStatus. However, this command has been
placed in the Provision DMP workflow to work around certain timing issues that
may arise when retrieving the Flash Template status
necessary to issue this final GetStatus. However, this command has been
placed in the Provision DMP workflow to work around certain timing issues that
may arise when retrieving the Flash Template status
You can see more detail about the steps and sub steps being performed by
viewing the status messages on the Console tab in the Device Details panel.
viewing the status messages on the Console tab in the Device Details panel.