Cisco Cisco StadiumVision Mobile Streamer Quick Setup Guide

IMPORTANT: If for some reason you needed to restore the SV-

4K operation to a new Cisco StadiumVision Director server (not a

failover operation), then you would need to change the DHCP

server option 43, reconfigure the new server for auto-provisioning

of the SV-4K, and reboot the SV-4K devices similar to a new

deployment of the SV-4K devices. For more information, see the

Replacing a Failed Media Player While an Event
Script is Running

This task describes the steps to replace a failed media player with a new device that

continues to follow the same script.

After replacement, the new media player should:

Belong to the same groups and zones.

Respond to the zone/group state actions.

Display the same content as the media player it replaces.

To replace a failed media player while an event script is running, complete the
following steps:

1. Unplug the failed device and replace it with a new device.

2. Wait until auto-registration and provisioning completes, and the new device

appears in the Management Dashboard.

3. From Control Panel > Setup > Zones & Groups, un-map the failed device from

its Location, and map the new device to this Location.

4. From Control Panel > Control, manually stage content to the new device.

5. (For SV-4K only) From the Management Dashboard, go to:

d. DMP and TV Controls > DMP Commands

e. Run the Restart Runtime command for the new SV-4K device only.

6. Verify that the new device is showing the expected content.

316 of 331