Cisco Cisco 1 GHz GainStar Amplifier Installation Guide
Installation and Configuration
18
To Install the Housing in a Pedestal
Complete the following steps to install the housing on a pedestal.
1 Drill two 3/8” holes in the mounting plate with 127 mm or 215.9 mm distance.
1 Drill two 3/8” holes in the mounting plate with 127 mm or 215.9 mm distance.
The thickness of the metal plate is 10 to 15 mm.
2 Lift the housing to the proper position on the wall or box.
3 Align the pedestal mounting holes on the bottom of the housing with the two
3 Align the pedestal mounting holes on the bottom of the housing with the two
holes drilled in the metal plate and insert the bolts into the two threaded
mounting holes.
mounting holes.
4 Using a ½-inch torque wrench, tighten the pedestal clamp bolts from 6.8 Nm to
9.0 Nm.
5 Connect the coaxial cable to the pin connector according to connector
manufacturer specifications.
6 Proceed to Installing the Accessories.