Cisco Model D9479 Gigabit QAM Modulator Installation Guide
Install GoQAM Software onto the DNCS
78-4024239-01 Rev B
15
Install GoQAM Software onto the DNCS
Introduction
This section describes how to install the new software onto the DNCS. Software is
installed from either of the following locations:
GoQAM Software V1.1.3 CD, part number 4011024. Go to Installing the GoQAM
Software from a CD (on page 15).
Cisco’s FTP server. Go to Installing the GoQAM Software from the Cisco FTP
Server (on page 16).
Installing the GoQAM Software from a CD
1 Insert the GoQAM V1.1.3 CD into the CD-ROM drive of the DNCS.
2 Did the File Manager window display?
2 Did the File Manager window display?
If yes, the CD mounted successfully. Go to step 4.
If no, type df -k to determine where the CD is mounted and then go to step 3.
3 Is /cdrom listed in the output?
If yes, go to step 4.
If no, contact Cisco Services.
4 From an xterm window where you are logged in as root, type cd /cdrom/cdrom0
and press Enter to access the cdrom0 directory.
5 Type /usr/sbin/install_pkg and press Enter.
Results:
The system lists the packages that will be installed.
A confirmation message appears asking you to confirm that you want to
proceed with the installation.
6 Type y and press Enter to start the installation. When the installation is complete,
the system displays a message stating that the installation was successful and a
prompt for the root user appears.
Note: The installation should take less than 30 seconds.
Note: The installation should take less than 30 seconds.
7 Was the installation successful?
If yes, go to step 8.
If no, contact Cisco Services.
8 From the xterm window where you are logged in as root, type exit and press
Enter. You are logged out as root user.