Cisco Cisco TelePresence Management Suite (TMS) Version 15 Document
Endpoint Products
Service
Protocol
Port
Number
Number
Allows Connections
(relative to system)
(relative to system)
HTTP
TCP
80
Outbound
SNMP
UDP
161
Inbound
SNMP Trap
UDP
162
Outbound
FTP
TCP
21
Inbound
FTP (data)
TCP
22
Outbound
Telnet*
TCP
23
Inbound
* Recommended, but not required for Cisco TMS management of system.
Note: Network systems that rewrite source addresses will interfere with communications to Cisco TMS
and proxies that require authentication may also hinder communications from systems to Cisco TMS.
and proxies that require authentication may also hinder communications from systems to Cisco TMS.
Cisco TMS Behind Firewall mode
Supported
Yes
Changes to
Requirements
Requirements
When configured for Behind Firewall connectivity, the network requirements change to only
require outbound connectivity via HTTP (TCP Port 80) or HTTPS (TCP Port 443) to Cisco
TMS. The managed device can also be behind a NAT device.
require outbound connectivity via HTTP (TCP Port 80) or HTTPS (TCP Port 443) to Cisco
TMS. The managed device can also be behind a NAT device.
Cisco TMS Secure-Only mode
Supported
No
Changes to
Requirements
Requirements
This system type is not supported by secure-only mode, so its configuration and network
requirements do not change.
requirements do not change.
Device Notes/Limitations
Cisco TMS does not automatically make endpoints answer calls. If Auto Answer is disabled, a user
must manually answer scheduled calls placed to the endpoint. Calls dialed out from the endpoint are
handled automatically.
must manually answer scheduled calls placed to the endpoint. Calls dialed out from the endpoint are
handled automatically.
To use pre-registration features, the ExternalManager Address setting must be configured in the
device for it to announce itself to Cisco TMS. The value can be set in the endpoint by an
administrator, through the setup wizard on the endpoint, or automatically via DHCP options.
device for it to announce itself to Cisco TMS. The value can be set in the endpoint by an
administrator, through the setup wizard on the endpoint, or automatically via DHCP options.