Cisco Cisco Prisma II EDR Receiver Installation Guide

78-748704-01 Rev C 

Installation 

2-7 

 Continued 

 

3. 

Attach the other 75-ohm RF cables to the Port B connector (RF output 1B), 

Port C (RF output 2A), and Port D (RF output 2B) connectors of the 

corresponding slot where the processor is to be installed  

4. 

Route the RF cables to the appropriate RF destinations.   

5. 

If F-connectors are installed, use a 7/16-in. open-end wrench to secure both 

cables to the connectors at the chassis.   

6. 

Proceed to the next section, Install the Processor in the Chassis.