Cisco Cisco Prisma II EDR Receiver Installation Guide
2-8
Installation
78-748704-01 Rev C
Install the Processor in the Chassis
Introduction
For best results, install the processor into the chassis before installing the optical
receivers into the processor.
If desired, the processor can be installed with the chassis powered up.
If desired, the processor can be installed with the chassis powered up.
Installing the Processor
Follow these steps to install the processor in the chassis.
1.
Locate the fiber guides at the bottom of the chassis and the module guide
slots inside the chassis as shown in the following illustration.
2.
Align the ridges on the top and bottom of the processor with the module
guide slots located on the chassis. Module ejectors must be fully extended
when inserting the processor.