Alcatel-Lucent omniaccess 6000 User Manual

Chapter 6

FE Management Port

The FE management port provides a 10/100 Mbps Ethernet connection to a 
management network. The RJ-45 female connector port pin-outs are shown 
in 

:

6-4  Management Port

The port accepts a 4- or 8-conductor Category 5 (or better) UTP Ethernet cable 
with an RJ-45 male connector. A straight-through cable is required for 
connection to a network port. A crossover cable is required for connection to 
a management workstation.

For cables that run through plenums or air-handling spaces as described in 
NEC (2002) Article 300.22(C), the cable should be suitable under NEC Article 
800.50 and marked accordingly for use in plenums and air-handling spaces 
with regard to smoke propagation, such as CL2-P, CL3-P, MPP or CMP. Be 
sure to install cables in accordance with all applicable local regulations and 
practices.

The supervisor card is hot-swappable and can be inserted into the Alcatel 
Wireless LAN Switch chassis while system power is on or off.

Verify you understand the procedure and all precautions.

Before beginning, read the entire procedure. Verify you understand all the 
precautions in these steps as well as those on 

10/100 Mbps Ethernet

RJ-45 Female
Pin-Out

 

1
2
3
4
5
6
7
8

ETH Tx+ 

 

ETH Tx– 

 

ETH Rx+ 

 

   

   

Direction

Receive

Transmit

 

—This procedure should be performed by a trained technician.