Alcatel-Lucent omniacces-voip gateway User Manual
VoIP Commands
Page 5-69
Command Usage
Specify time to wait before first tone (digit) is sent (dialed out) after going off-hook.
Syntax Options
voice signaling out wait
voice signaling channel <
slot/port/startChannel-endChannel
> out wait <
value
>
Definitions:
slot
slot
Specifies slot number of voice daughtercard installed in switching module, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
value
When tone dialing is used, specifies in milliseconds from 0 ms to 20,000, the time to delay
after going off-hook before sending the first outbound dial digit (e.g.,
after going off-hook before sending the first outbound dial digit (e.g.,
20000
).
♦ Syntax Note ♦
Do not use commas when entering the time to delay after going
off-hook before sending the first outbound dial digit (for exam-
ple,
off-hook before sending the first outbound dial digit (for exam-
ple,
20,000
will return a syntax error message).
Default:
The default value is
The default value is
400
.
Command Examples:
voice signaling channel 2/1/1-12 out wait 0
voice signaling channel 2/2/13-24 out wait 400
voice signaling channel 2/3/1-30 out wait 20000
voice signaling channel 2/2/13-24 out wait 400
voice signaling channel 2/3/1-30 out wait 20000