Alcatel-Lucent omniacces-voip gateway User Manual
VoIP Commands
Page 5-142
Command Usage
Specify Foreign Exchange Office Ground Start (FXO GS) time between consecutive ring
pulses.
pulses.
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
FXO (Loop and Ground Start) commands will take effect.
voice signaling fxo gs ringing inter pulse
voice signaling channel <
slot/port/startChannel-endChannel
> fxo gs ringing inter pulse <
value
>
Definitions:
slot
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
value
Specifies the time between fxo gs start time between consecutive ring pulses in the same
ring cycle, in milliseconds from 1 to 60,000, (e.g.,
ring cycle, in milliseconds from 1 to 60,000, (e.g.,
550
), to detect ringing.
♦ Syntax Note ♦
Do not use commas when entering the fxo gs start time between
consecutive ring pulses to detect ringing (for example,
consecutive ring pulses to detect ringing (for example,
5,000
will return a syntax error message).
Default:
The default value is
The default value is
550
milliseconds.
Command Examples:
voice signaling channel 2/1/1-12 fxo gs ringing inter pulse 550
voice signaling channel 2/2/13-24 fxo gs ringing inter pulse 30000
voice signaling channel 2/3/1-30 fxo gs ringing inter pulse 60000
voice signaling channel 2/2/13-24 fxo gs ringing inter pulse 30000
voice signaling channel 2/3/1-30 fxo gs ringing inter pulse 60000