Alcatel-Lucent omniacces-voip gateway User Manual
VoIP Commands
Page 5-143
Command Usage
Set Foreign Exchange Office (FXO) Ground Start (GS) to detect inbound caller ID (on/off).
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
FXO (Loop and Ground Start) commands will take effect.
voice signaling fxo gs caller id detection
voice signaling channel <
slot/port/startChannel-endChannel
> fxo gs caller id detection {on | off}
Definitions:
slot
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
on
Turns ON fxs gs caller ID detection for specified telephony signaling channel.
off
Turns OFF fxs gs caller ID detection for specified telephony signaling channel.
♦ Syntax Note ♦
The
voice coding profile caller id
command must be enabled to
use this command.
Default:
The default setting is
The default setting is
off
.
Command Examples:
voice signaling channel 2/1/1-12 fxo gs caller id detection off
voice signaling channel 2/2/13-24 fxo gs caller id detection on
voice signaling channel 2/2/13-24 fxo gs caller id detection on