Alcatel-Lucent omniacces-voip gateway User Manual
VoIP Commands
Page 5-144
Command Usage
Specify Foreign Exchange Office (FXO) Ground Start (GS) number of rings allowed before
answering.
answering.
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
FXO (Loop and Ground Start) commands will take effect.
voice signaling fxo gs answer after
voice signaling channel <
slot/port/startChannel-endChannel
> fxo gs answer after <
value
>
Definitions:
slot
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
value
Specifies the number of rings permitted to elapse before answering incoming calls, per ring
from 1 to 65,535, (e.g.,
from 1 to 65,535, (e.g.,
2
) rings.
♦ Syntax Note ♦
Do not use commas when entering the fxs gs call answer after
rings value (for example,
rings value (for example,
10,000
will return a syntax error
message).
If caller ID is ON, then the number of rings should be greater
than or equal to 2 rings.
than or equal to 2 rings.
Default:
The default value is
The default value is
50
rings.
Command Examples:
voice signaling channel 2/1/1-12 fxo gs answer after 50
voice signaling channel 2/2/13-24 fxo gs answer after 5
voice signaling channel 2/3/1-30 fxo gs answer after 1000
voice signaling channel 2/2/13-24 fxo gs answer after 5
voice signaling channel 2/3/1-30 fxo gs answer after 1000