3com 9000 SX User Manual
Port Commands
4-23
Configuration and
Image Commands
Table 4-19 Configuration and Image Commands
Command
Description
save {config} {primary | secondary}
Allows you to save the current configuration of the
Switch to NVRAM. You can specify the primary or
secondary configuration area. If not specified, the
configuration is saved to the configuration area
currently in use.
Switch to NVRAM. You can specify the primary or
secondary configuration area. If not specified, the
configuration is saved to the configuration area
currently in use.
use config {primary | secondary}
Allows you to configure the Switch to use a particular
configuration on the next reboot. Options include the
primary configuration area, the secondary
configuration area, or an imported ASCII file. If not
specified, the Switch will use the primary configuration
area.
configuration on the next reboot. Options include the
primary configuration area, the secondary
configuration area, or an imported ASCII file. If not
specified, the Switch will use the primary configuration
area.
use image {primary | secondary}
Allows you to configure the Switch to use a particular
image on the next reboot. If not specified, the Switch
will use the primary image.
image on the next reboot. If not specified, the Switch
will use the primary image.
download image <ipaddress> <filename>
{primary | secondary}
{primary | secondary}
Allows you to download a new image from a TFTP
server. You must specify the IP address of the TFTP
server and the image filename. You can optionally
specify if you want the file downloaded to the primary
or secondary image. If you do not specify, the file is
downloaded to the primary image.
server. You must specify the IP address of the TFTP
server and the image filename. You can optionally
specify if you want the file downloaded to the primary
or secondary image. If you do not specify, the file is
downloaded to the primary image.
SW9000.BK Page 23 Wednesday, April 1, 1998 11:00 AM