HP C7000 User Manual
Removal and replacement procedures 43
To replace the component, reverse the removal procedure.
Rear cage
WARNING:
To reduce the risk of damage to the midplane and component connectors, always
remove or disengage and extend all blades and power supplies 7.62 cm (3 in) before
removing or installing the rear cage.
WARNING:
To reduce the risk of personal injury or equipment damage, at least two people
are needed to safely move the rear cage.
IMPORTANT:
When removing components from the rear cage, note their position for later
replacement.
To remove the component:
1.
Power down the server blades ("
" on page
2.
Power down the enclosure (on page
3.
Disconnect all cables.
4.
Disengage and extend the following components approximately 7.62 cm (3 in):
o
Half-height and full-height blades ("
o
Power supplies ("
o
Power supply blanks ("
5.
Remove the fans ("
6.
Remove the fan blanks ("
" on page
7.
Remove the interconnect switches and Pass-Thru modules ("
on page
8.
Remove the interconnect blanks ("
9.
Remove the Onboard Administrator tray ("
For this procedure, you can remove the Onboard Administrator tray with the Onboard Administrator
modules or blanks installed.
modules or blanks installed.
10.
Remove the rear cage:
a.
Loosen the thumbscrews and open the hinges completely.