HP C7000 User Manual
Removal and replacement procedures 49
12.
Disconnect the pass-thru board from the cable.
To replace the component, reverse the removal procedure.
Midplane assembly
WARNING:
To reduce the risk of damage to the midplane and component connectors, always
remove or disengage and extend all blades and power supplies 7.62 cm (3 in) before
removing or installing the rear cage.
To remove the component:
1.
Power down the server blades ("
" on page
2.
Power down the enclosure (on page
3.
Disconnect all cables.
4.
Disengage and extend the following components approximately 7.62 cm (3 in):
o
Half-height and full-height blades ("
o
Power supplies ("
o
Power supply blanks ("
5.
Remove the fans ("
6.
Remove the fan blanks ("
" on page
7.
Remove the interconnect switches and Pass-Thru modules ("
on page
8.
Remove the interconnect blanks ("
9.
Remove the Onboard Administrator tray ("
For this procedure, you can remove the Onboard Administrator tray with the Onboard Administrator
modules or blanks installed.
modules or blanks installed.