JVC 0210TTH-SW-VP User Manual

Assigning IP Address from the
DHCP Server

The IP address is automatically assigned by the DHCP
server.

After connecting, turn on the main power

● Refer to Page 24 on the details of connection.

● Refer to Page 25 on procedures to turn on the main

power.

Set the

ADHCP ClientB setting of this

projector to

ADHCPB

● The ADHCP ClientB of this projector is set to

ASTATIC IPB (the DHCP client function is OFF) by
default. When assigning an IP address from the
DHCP server, access this projector from the
computer to alter the settings. For details on the
setting procedures, refer to

ASetting (Changing) the

IP address of this projector

B. (A Page 27)

NOTE:

● Please consult the network administrator on the IP

address assigned to this projector.

● When ADHCP ClientB is set to ADHCPB, and if the

projector is started up in a LAN where a DHCP server
does not exist, the projector will start up using the
default IP address instead.

CAUTION:

● Configure the DHCP server such that the same IP

address is assigned to the

AMac AddressB of this

projector by the DHCP server at all times. Connection
may fail if the above setting is not performed.

This feature enables delivery of mail (error message) to
the preset e-mail address when error occurs inside this
projector unit.

Connection Example (When
DHCP Server is Used)

Connecting this projector and the computer
using a USB cable

You can connect this projector and the controlling
computer using a USB cable.

● You need to install a driver in order to connect the

projector and computer using a USB cable.

NOTE:

● For details on the installation of the USB driver,

please consult your authorized dealer.

Using the Mail Delivery
Feature

LAN1

WAN

LAN2 LAN3 LAN4

ETHER

OPERATE I/

DVI 3

USB

LAN

RS-232C

STANDBY/ON

CONTROL

LAMP

WARNING

DVI 4

DVI 1

DVI 2

DHCP Server

LAN

To LAN Terminal

ADSL modem, etc.

To Internet Connection