JVC 0210TTH-SW-VP User Manual

If setting for this projector is not completed, refer to 

B(A Page 33) upon turning on the power 

and configure the settings accordingly.
Once the basic settings are configured, this projector can 
be used by simply performing the following operation 
procedures.

● Remove the lens cap.

● Connect this projector to the computer. (A Page 21, 23)

● Connect the LAN cable. (A Page 24)

● Refer to ATurning On the Main PowerB 

A Page 25), and steps 4 to 6 of 

● The [STANDBY/ON] indicator lights up in red.

● The power of this projector turns on, and formatting 

is done taking a few minutes. A gray image will be 
displayed during formatting. The projected image 
appears once formatting ends.

● The [STANDBY/ON] indicator lights up in green.

● You can also turn on the power by pressing the 

[OPERATE I/

B] button on the projector unit for more 

than one second.

● The image may flicker for a few seconds immediately 

after projection starts. This is not a malfunction.

● After the lamp lights up, it takes about 1 minute or 

longer for the brightness of the video image on the 
screen to stabilize.

You can adjust the focus using the 

AZoomB item of the 

Lens menu. 

 To enlarge the screen size:

Press the 

AWB (Wide) end of AZoomB

 To reduce the screen size:

Press the 

ATB (Tele) end of AZoomB

● The screen size changes each time you click on the 

inner buttons ( / ). (Fine control)
The outer buttons ( / ) change the screen size when 
they are depressed. (Coarse control)

You can adjust the focus using the 

AShiftB item of the 

Lens menu.

 To shift the image upward:

Press the 

AUB end of AShiftB

 To shift the image downward:

Press the 

ADB end of AShiftB

 To shift the image rightward:

Press the 

ARB end of AShiftB

 To shift the image leftward:

Press the 

ALB end of AShiftB

● When a zoom lens is used, the adjustment range for 

lens shift is between 0 % to ±50 % in the vertical 
direction, and between 0 % to ±25 % in the horizontal 
direction (during single-screen display).
When a short focal length lens is used, the adjustment 
range for lens shift is between 0 % to ±15 % in the 
vertical direction, and between 0 % to ±5 % in the 
horizontal direction (during single-screen display). 
(

● The position changes each time you click on the inner 

buttons ( / ). (Fine control)
The image shifts when the outer buttons ( / ) are 
depressed. (Coarse control)

● The lens shift feature does not function if the lens 

mechanism is secured.( 

 DVI 

Rate(Hz) 

Pixel H 

Pixel V 

Link

 1 

60.00 

2048 

2400 

Dual

 2 

 

 

 

 3 

60.00 

2048 

2400 

Dual

 4 

 

 

 

host PJ-1
user: root

 Lamp Status  Time

 1 

ok 

10h54m

 2 

ok 

11h58m

Lamp

26.8 deg.C

Outside

26.3 deg.C

Inside

34.0 deg.C

PROJECTION

None

host PJ-1
user: root

OFF

OFF