Toshiba e-studio 165 User Manual

Troubleshooting at Network Printing Setups    39

This section describes troubleshooting when you are setting up network printing. Network print-
ing is enabled when the Network Printer Kit is installed.
The items in the table below are described in this section, and are transcribed from other manu-
als (in PDF files) of this equipment. 

For troubleshooting when the setups have been completed, see the following page:

When a computer cannot print data to this equipment through a network, check if the settings 
are correctly made according to the Network Administration Guide for Printing Functions by 
referring to the checklists shown below. The checklist covers major printing setting items 
explained in the Network Administration Guide for Printing Functions.

Network setting checklists

Equipment detection and printing check

Printer driver installation error messages

1

Are the IP Address proper-
ties correctly set?

Next Step

Set up the IP address correctly.

2

Is the Raw TCP Printing 
correctly set?

Next Step

Set up the Raw TCP print service 
correctly.

3

Is the LPR/LPD Printing cor-
rectly set?

Next Step

Set up the LPD print service cor-
rectly.

4

Were the proper printer driv-
ers installed?

Next Step

See the Printing Guide to install 
proper printer drivers.

5

Is the Raw TCP or LPR port 
configured with correct IP 
address?

Next Step

See the Printing Guide to config-
ure the proper port.

6

Can you print to this equip-
ment?

Refer to the following section to 
troubleshoot the condition.