Yamaha cd-r1000 User Manual

Chapter 3—The Basics

This section explains how to load and unload discs.

Press the [OPEN/CLOSE] button to open the disc tray.

The disc tray opens and “OPEN” appears on the display.

Place the disc in the center of the disc tray with the labeled side facing up.

Press the [OPEN/CLOSE] button again to close the disc tray.

The disc tray closes and “CLOSE” appears on the display.

If the disc tray opens again, make sure the disc is seated correctly in the disc tray.

The disc tray can also be closed by pushing it gently. Do not use excessive force to push 
the tray when the CDR1000 is turned off, as this may damage the mechanism.

To unload a disc, stop the current operation, press the [OPEN/CLOSE] button 
and remove the disc when the disc tray is fully open.

The following table lists the disc-related display messages and their meanings.

When a disc is loaded, the CDR1000 determines the type and status of the disc, and 
then the relevant disc-type indicator lights up, as shown in the following table.

The disc tray is opening.

The disc tray is closing.

The CDR1000 is determining the type of disc and reading its table of 
contents.

The CDR1000 is performing OPC (Optimum Power Control). See 
“OPC” on page 4 for more information.

No disc is loaded.

An unrecorded disc is loaded.

The loaded disc cannot be used for recording. Finalize it, or load 
another disc.

The loaded disc cannot be played because it contains data, perhaps it’s 
a CD-ROM. Load another disc.

The wordclock input signal is out of the range of the sampling rate 
converter. See “Setting the Sampling Rate Converter” on page 26.

The CDR1000 is initializing.

The loaded disc is not a CD, CD-R, or CD-RW. Load another disc.

A prerecorded audio CD or finalized CD-R disc

Unfinalized CD-R disc

CD-RW disc