Yamaha HTR-5930 User Manual

Once all connections are complete, plug the power cable 
into the AC wall outlet.

Before connecting the power cable into the AC wall outlet, 
check that the impedance selector setting is correct.

The VOLTAGE SELECTOR on the rear panel of this unit 
must be set for your local voltage BEFORE plugging the 
power cable into the AC wall outlet. Improper setting of 
the VOLTAGE SELECTOR may cause damage to this 
unit and create a potential fire hazard.

Select the switch position (upper or lower) 
according to your local voltage using a straight 
slot screwdriver.
Voltages are 110-120/220-240 V AC, 50/60 Hz.

When all connections are complete, turn on this unit.

Press STANDBY/ON on the front panel again (or press 
STANDBY on the remote control) to set this unit to the 
standby mode.

The memory back-up circuit prevents the stored data 
from being lost even if this unit is in the standby mode.
However, the stored data will be lost in case the power 
cable is disconnected from the AC wall outlet or if the 
power supply is cut off for more than one week.

l

h

l      PROGRAM       h

l      INPUT      h