PAC swi-ps User Manual

Page of 8
Wiring Connections
Step 1.
Connect the BLACK 
wire to ground (-).
Verification: Wire 
or location registers 
a constant (-) when 
probed.
Step 2.
Connect the RED wire 
to switched +12V.
Verification: Wire reg-
isters +12V when the 
ignition key is turned 
to the ACC or ON posi-
tions.
Step 3.
Connect the appropriate interface wire (WHITE, YELLOW, ORANGE or 
GREEN).
• Refer to the 
Identification and Connection Chart. Locate the vehicle and 
note the SWC wire color in the “Interface Wire Color” column. 
• Note the vehicle wire color and location information in the “Identification” 
column.
Note: You will only connect ONE of these wires. The other 3 wires will not 
be used. Cut and insulate the unused wires. 
• Connect the wire as indicated in the chart.
Note: Only 3 wires will be used during installation. Only GM vehicles programmed for version #4, will use  4 wires.
Step 4a.
Connect the BLUE 
serial data wire.
Connect this wire 
ONLY on GM 
passenger vehicles (no 
trucks or SUVs) with 
airbags AND steering 
wheel heater controls. 
For all other vehicles, 
cut and insulate the 
BLUE wire.
Step 4b.
If instructed by the 
Vehicle Application 
Guide, cut the 
BROWN wire loop and 
insulate both halves.
Step 4c.
If instructed by the 
Vehicle Application 
Guide, cut the VIOLET 
wire loop and insulate 
both halves, or place a 
resistor in-line of wires.
Note: 
Step 4a is for vehicles made by 
General Motors that are programmed 
for version #4 only. If no connections is 
necessary, proceed to Step 4b.
Step 4
If necessary, perform the following operations as indicated by the notes in Identification and Connection Chart.