PAC swi-ps User Manual

Step 18.

Press and

hold program-

ming/mode

button on

SWI-PS.

LED will light.

Step 19.

Release

programming/

mode button.

SWI-PS

You only need to press the programming/mode button once to program all the buttons. If you press this button again after the

interface is programmed, it will erase all previous learned buttons.

SWI-PS

If you programmed the interface for version #4, proceed with the following steps.

If you did not program the interface for version #4, skip to Step 8.

Step 12.

Press and hold

programming/

mode button

on SWI-PS.

Step 14.

Press and hold the TEMP UP

button on the steering wheel

control.

LED will turn off.

LED will light.

Step 13.

Release

programming/

mode button.

Step 15.

Release the TEMP UP button.

LED will turn on. The

function is pro-

grammed.

Step 16.

Repeat Steps 14 and 15, using the TEMP DOWN Button.

Step 17a.

If the vehicle is equipped with FAN UP and FAN DOWN buttons:

Repeat Steps 14 and 15 for these buttons as well.

Step 17b.

If the vehicle is NOT equipped with FAN UP and FAN DOWN buttons:

Press and release the programming/

mode button on the SWI-PS.

SWI-PS

In either case, the

LED will flash once

and stay on.

Skip to Step 0.

You have 7 sec-

onds to perform

the next step.

SWI-PS

Programming the SWI-PS to Control the Head Unit

Step 11.

Turn the vehicle ignition to

the ON position.

LED will flash to

indicate set version

number.

OFF

ACC

IGN

STRT

TEMP

IMPORTANT! Some steps of the programming instructions must be completed within a certain number of seconds following the

previous step. Review the complete instruction before beginning the programming sequence.