Fujitsu sparc m3000 User Manual

2-8

C120-E360-06EN

CHAPTER 2  Setup of the RCI for Operation 

The added RCI host must be connected to the RCI network.

The RCI address of the added RCI host is synchronized with those of existing RCI 
hosts so that the added cabinet can use RCI functions.

Make an RCI expansion setting on the added RCI host.

Note:

Before beginning this RCI setup work, confirm that AC cables are connected 
to all RCI units.

Note:

To make an RCI expansion setting for an RCI unit equipped with a main line 
switch, set the main line switch to the ON position.

• To make an RCI expansion setting:

1

Execute the setrci (8) command, and make an RCI expansion setting.

• To confirm an RCI expansion setting:

1

Execute the setrci (8) command to display the RCI status.

Confirm that the displayed LIST contents include the added RCI host.
For details on LIST contents, see 

XSCF> setrci -c addconfig
....................................................
The command completed successfully.

XSCF> setrci -c stat
HOST
 address 000102ff
 Active
LIST
 address  pwr alm I/F   sys-phase   tgry dev-cls sub-cls tm-out
 000101ff OFF -   ACT   -          host  0001   0b      -
 000102ff OFF -   ACT   -          host  0001   0b      -
 003001ff OFF -   ACT   -          disk  0400   04      -
The command completed successfully.