Fagor nc-200 pb Installation Instruction

Special configurations.

Digit

8 to 5

Not being used at this time. They must be set to "0".

4

Only for the "B" model.

If = 0, the feedback device for the ram/table position is a linear encoder.

If = 1, the feedback device for the ram/table position is linear potentiometer.

3

Axis positioning mode.

If =0, The axes move at the same time.

If =1, The axes move one after the other (1st X and then Y).

Both axes may be positioned with the same inverter using the relevant
enable signals to toggle the power connection fine tuning the adjustment
of the X axis to avoid rebounds at the final positioning.

2

If = 1, the feed towards "X-" will be forced with I32 (safety regulations
for rapid feed).

Install a push button on the operator panel for starting each bending
sequence when moving towards "X-". I32 is shared with the micro switch
detecting the contact between the punch and sheet metal.

1

If = 1, There is a detector for punch-sheet contact.

Use the "B" attribute to provoque the return of the X axis.

It requires a previous flank at I32 to confirm the change of block with
I13.

If = 0, there is no detector. The "B" attribute is ignored.

If the bending sequence is interrupted and the ram returns to the top dead
position, I13=1, it provoques the uncontrolled block feed.

Indicates the transmission speed of the RS 232 line.

Options: 75, 150, 300, 600, 1200, 2400, 4800 & 9600 baud.

Factory setting: 9600 baud

This NC sends and receive data at the speed set by PAR90 and with
the following configuration:

Stop bits: 1

Data bits: 8

Parity: None

Protocol: XON/XOFF