Zebra Technologies barcode anything s400 User Manual
Zebra S400 & S600 User’s Guide
23
&RQQHFWLQJWKH3ULQWHUDQG&RPSXWHU
This printer comes with both a nine-pin Electronics Industries Association
(EIA) RS-232 serial data interface and an IEEE 1284 bi-directional
parallel data interface. In either case, you must supply the required
interface cable for your application.
(EIA) RS-232 serial data interface and an IEEE 1284 bi-directional
parallel data interface. In either case, you must supply the required
interface cable for your application.
CAUTION: This printer complies with FCC “Rules and
Regulations,” Part 15, for Class B Equipment, using fully
shielded six-foot data cables. Use of longer cables or
unshielded cables may increase radiated emissions above the
Class B limits.
Regulations,” Part 15, for Class B Equipment, using fully
shielded six-foot data cables. Use of longer cables or
unshielded cables may increase radiated emissions above the
Class B limits.
56,QWHUIDFH5HTXLUHPHQWV
Refer to Figure 6 on page 8.
The required cable must have a 9-pin “D” type (DB-9P) connector (male)
on one end, which is plugged into the mating (DB-9S) connector (female)
located inside the access opening on the left side of the printer.
on one end, which is plugged into the mating (DB-9S) connector (female)
located inside the access opening on the left side of the printer.
The other end of the signal interface cable connects to a serial port at the
host computer. This cable is one of two types — standard or null modem
— depending on the specific interface requirements.
host computer. This cable is one of two types — standard or null modem
— depending on the specific interface requirements.
For pinout information, as well as information on how to interconnect to
either a DTE (data terminal equipment) or DCE (data communication
equipment) device, refer to the “Appendix” on page 67.
either a DTE (data terminal equipment) or DCE (data communication
equipment) device, refer to the “Appendix” on page 67.
3DUDOOHO,QWHUIDFH5HTXLUHPHQWV
Refer to Figure 6 on page 8.
An IEEE 1284 compatible bi-directional parallel data cable is required
when this communication method is selected. The required cable must
have a standard 36-pin parallel connector on one end, which is plugged
into the mating connector located inside the access opening on the left side
of the printer. The parallel interface cable is connected using bail clips
instead of screws.
when this communication method is selected. The required cable must
have a standard 36-pin parallel connector on one end, which is plugged
into the mating connector located inside the access opening on the left side
of the printer. The parallel interface cable is connected using bail clips
instead of screws.