Nilfisk neptune e User Manual

12

english

1)

Accessories / model variants

NEPTUNE E

1. Turn the main switch to posi-

tion „OFF“.

2. Tur n off water supply at 

faucet.

3. Squeeze the spray gun trig-

ger until the pressure has bled 
off.

4. Slide trigger lock to the locked 

position.

0

I

M

1. Tur n off water supply at 

faucet.

2. Remove the water supply 

hose from the cleaner.

6. To prevent accidents, always 

1. Store the cleaner in a dry 

heated location to protect 
against freezing.

carefully roll up the power 
cord and the high pressure 
hose.

These are merely several examples of cleaning tasks that can be solved by a pressure washer in asso-
ciation with accessories and detergents. Each cleaning task is different. Please consult your local dealer 
or Nilfisk-Alto representative in order to discuss the best solution for your own cleaning tasks.

General surfaces

Metallic equipment

Foam injectors 
Standard lance
Curved lances
Tank cleaning
head

Detergents
Intensive
J25 Multi
Combi Aktive
Alkafoam

Disinfectant
DES 3000

1. Apply thick foam over the surfaces to be cleaned. Ap-

ply on dry surfaces. Apply from top to bottom on ver-
tical surfaces. Let the foam act for up to 30 minutes 
for the optimal effect.

2. Proceed with cleaning using the high pressure lance.  

Use applicable accessories. Use high pressure to 
dislodge large amounts of incrusted dirt or grime. 
Use lower pressure and high water volume in order 
to rapidly flush away loose dirt and rinse surfaces.

3. Apply DES 3000 disinfectant once the surfaces are 

perfectly clean.

Areas covered by amounts of loose dirt, such as animal 
remains in slaughterhouses, can be removed by using 
high water flow to flush away the dirt to evacuation pits 
or drains.
Tank cleaning heads can be used to clean barrels, vats, 
mixing tanks etc. Cleaning heads may be hydraulically 
or electrically powered and give the possibility for auto-
matic cleaning without a constant user.

Rusted or 
damages surfaces 
prior to treatment

Wet Sandblasting 
equipment

1. Connect the sandblasting lance to the pressure 

washer and place the suction tube in the sand.

2. Always wear protective equipment during sandblast-

ing.

3. Spray the surfaces to be treated with the mix of water 

and sand. Rust, paint etc will be stripped off.