Crestron hbk-3000 smk-3000 User Manual

Hatch Back & Swivel Mount Kits 

Crestron HBK-3000 & SMK-3000 

The hardware supplied in the kits is listed in the following table. 

One (1) Metal Bracket 

One (1) Swivel Mount Assembly 

One (1) Plastic Cover 

One (1) Metal Bracket 

Four (4) Screws 4-40 X 3/16 inch 

One (1) Metal Plate 

 

One (1) Plastic Cover 

 Sixteen 

(16) 

Screws 

  (4) 4-40 X 3/16-inch 
  (4) 6-32 X 1/2-inch 
  (4) 8-32 X 5/8-inch 
  (4) 8-32 X 1-inch 

* The SMK-3000 mounting kit includes a template for preparing the mounting 
surface. 

This section provides an installation procedure for each kit. The only 
tools required are #1, #2, and #3 Phillips screwdrivers. 

To attach the HBK-3000 Hatch Back Kit to the TPS-3000 Touchpanel, 
refer to the illustration on page 3 and perform the associated procedures. 

1.  Remove the two screws A from the rear of the touchpanel that 

correspond to the holes in the mounting tabs of the Metal Bracket. 

2.  Put the Metal Bracket in position on the rear of the touchpanel 

base (mounting holes should align, and standoff posts should be 
oriented as shown in the illustration). Secure the Metal Bracket to 
the touchpanel using the two screws A removed in step 1.  

3.  Make certain cable connections are secure, put the Plastic Cover 

in position with the cables routed through the rear opening. Secure 
the cover to the Metal Bracket using the four # 4-40X 3/16-inch 
screws B supplied. 

• Hatchback & Swivel Mount Kits:  HBK-3000 & SMK-3000