Crestron hbk-3000 smk-3000 User Manual

Crestron HBK-3000 & SMK-3000    Hatch Back & Swivel Mount Kits 

To attach the SMK-3000 Swivel Mount Kit to the TPS-3000 Touchpanel 
and install the assembly on a suitable mounting surface, refer to the 
following procedures and the illustration on page 5. 

1.  Prepare the mounting surface using the template provided with the 

kit. The center hole for the swivel assembly should be 2.5-inches 
minimum; 2.6-inches maximum. Position the template so that the 
edge indicated as ‘front’ aligns with desired front position of the 
touchpanel. Observe the dashed line indicating front edge of the 
touchpanel base to ensure the touchpanel will not overhang the 
mounting surface. 

2.  If necessary, to prevent errors when reconnecting, label and 

disconnect any cables connected to the touchpanel. 

3.  Place the touchpanel face down on a padded surface to prevent 

damage to the display screen. Adjust tilt angle if needed. Avoid 
putting pressure on the display housing. 

4.  Refer to the assembly view for the HBK-3000 Hatchback Kit 

above and remove the two screws A from the rear of the 
touchpanel that correspond to the Mounting Holes in the Metal 
Bracket. 

• 3