Crestron hbk-3000 smk-3000 User Manual

Hatch Back & Swivel Mount Kits 

Crestron HBK-3000 & SMK-3000 

5.  Put the Metal Bracket in position on the rear of the touchpanel 

base (mounting holes should align, and standoff posts should be 
oriented as shown in the illustration). Secure the Metal Bracket to 
the touchpanel using the two screws A removed in step 4. 

6.  Refer to the illustration on page 5, and route the cables from the 

interface box up through the Metal Plate, through the mounting 
surface and through the Swivel Assembly, then through the area 
of the bracket shown in the figure, and connect to the appropriate 
touchpanel ports. Route the cables carefully to avoid chafing. 

7.  Being careful to avoid damage to the cables, attach the Swivel 

Assembly to the base of the touchpanel, using the supplied four 
#6-32 X 1/2 inch screws C through the swivel assembly standoff 
posts into the threaded holes in the touchpanel base. Make certain 
the cables are not twisted or crimped and have sufficient slack at 
the port connections before fully tightening the screws.  

8.  Make certain tab D is positioned to the front of the swivel 

assembly, and that it is directly opposite bent tab F, and place the 
touchpanel and swivel mount assembly down on the Mounting 
Surface. 

9.  Hold the Metal Plate in position under the mounting surface and 

secure the assembly in place using the #8-32 screws G provided 
(use the 5/8-inch screws for surfaces 3/4-inch to 1 1/8-inches 
thick; use the 1-inch screws for surfaces 1 1/8 to 1 3/8 inches 
thick). Use screws E to adjust tension of the swivel assembly. 

10. Again, refer to the HBK-3000 illustration on page 3, and put the 

Plastic Cover in position and secure to the Metal Bracket using 
the four #4-40 X 3/16-inch screws B supplied.  

• Hatchback & Swivel Mount Kits:  HBK-3000 & SMK-3000