Navman la000508 User Manual

Page of 18
1
LA000507G © 2006 Navman New Zealand. All rights reserved. Proprietary information and specifications subject to change without notice.
Table 5‑3 shows the software features available with the Jupiter 20 configurations.
Feature
Description
J20
GSW2.3
J20S
XTrac
J20D
SiRFDrive
SBAS capability
Improves position accuracy by using freely available 
satellite‑based correction services called SBAS (Satellite 
Based Augmentation System)
A
A
DGPS ready
Accepts DGPS corrections in the RTCM SC‑104 format
E
E
TricklePower
Improves battery life using this enhanced power management 
mode
A
A
Adaptive 
TricklePower
Intelligently switches between TricklePower and full power 
depending on the current GPS signal level (when TricklePower 
is enabled)
E
yes
Advanced power 
management
Improves battery life using a software‑based power 
management
A
Push‑to‑Fix
Provides an on‑demand position fix mode designed to further 
improve battery life
A
A
Almanac to 
Flash
Improves cold start times by storing the most recent almanac to 
flash memory
yes
yes
Low signal 
acquisition
Acquires satellites and continues tracking in extremely low 
signal environments
yes
Low signal 
navigation
Continues navigating in extremely low signal environments
yes
1 PPS
A timing signal generated every second on the second
E
E
yes
=always enabled     
A = available     E = enabled by default in production units
Table 5-3: Jupiter 20 software capability
6.0 Dead Reckoning input specifications
6.1 Gyro input specification
The specifications shown in Table 6‑1 apply to the Jupiter 20D only.
Characteristics
Value
Unit
input max voltage range
max +5, min 0
VDC
input resistance nominal
18.2
nominal bias at zero angular velocity
2.5
VDC
nominal scale factor
22.2
mV per degrees/s
linearity
± 0.5 max
%
angular resolution
0.055
degrees/s
max gyro angular rate
± 80
degrees/s
Note that clockwise rotation should cause the input to rise
Table 6‑1: Gyro input specifications
At the time of publication, recommended manufacturers of gyros are as follows:
Murata ENV series
Panasonic EWTS series
(Navman takes no responsibility for the use of these gyros in an application.)
6.2 Wheel tick rate
The wheel tick rate is 4 kHz maximum, 1 Hz minimum.
6.3 Fwd/Rev input sense
The fwd/rev input sense is: LOW=forward, HIGH=reverse. External pull down is required if this 
input is not used.