Nilfisk attix 751-2m User Manual

13

english

ATTIX 360-2M

ATTIX 550-2M / ATTIX 560-2MXC
ATTIX 751-2M / ATTIX 761-2MXC

1) 

Option depending on model

7. Check the antistatic clamp 

(5) for damage and have it 
replaced by Nilfisk-Alto Serv-
ice if necessary.

8. Check that the control flap 

(6) for filter cleaning works 
properly. The control flap 
should move back and for-
wards easily.

9.  Clean the level hose (7).
10. Fit a new filter element.
11. 

Fit the filter holder. Ensure 
that it is in the correct posi-
tion.

12. Fit bar and close bar handle.
13. 

Dispose of the used filter 
element in accordance with 
legal regulations.

Never use the vacuum cleaner 
without a filter.

1) 

Accessory. Order No. shown in section 9.5.

‡ Motor does not start

> Fuse of the mains socket has 

blown.

•

Connect mains fuse.

> Overload protection switch 

has tripped.

•

Switch off the vacuum cleaner 
and allow it to cool for approx. 
5 minutes. If the cleaner can-
not be started again, contact 
the Nilfisk-Alto service depart-
ment.

> Self-acting carbon brush is 

worn.

•

Have carbon brushes changed 
by Nilfisk-Alto Service.

‡ Motor does not run in auto-

matic mode

> Power tool is defective or not 

connected properly.

•

Check that the power tool 
works or that the plug is in-
serted correctly.

> The power rating of the elec-

trical tool is too low.

•

Note that minimum power rat-
ing is P>40W

‡ The acoustic warning 

sounds. (Reduced suction 
power)

> Suction power selected with 

suction power control is too 
low.

•

Set suction power in accord-
ance with section 4.2.3. „Set-
ting suction power“.

> Hose diameter and switch 

position do not correspond.

•

Set correct switch position for 
hose diameter.

> Clogged suction hose/nozzle.

•

Clean suction hose/nozzle

> Filter bag is full.

•

See section 7.2.2 „Replacing 
filter bag“.