Panasonic PTLZ370E Operating Guide

You can set the logo display when the power is turned 

on.

1)  Press ▲▼ to select [STARTUP LOGO].
2)  Press ◀▶ to switch [STARTUP LOGO].

▶

z

The setting will change as follows each time 

you press the button.

Projects the Panasonic logo.

[USER LOGO] Projects the logo transferred with 

“Logo Transfer Software”

*1

.

Disables the startup logo display.

*1:  “Logo Transfer Software” is included in the attached CD-

ROM.

 

z

To create the image for [USER LOGO], “Logo 

Transfer Software” included in the supplied CD-

ROM is required.

 

z

The startup logo will disappear in approximately 30 

seconds.

 

z

The startup logo is not displayed even when 

[USER LOGO] is selected, if the log has not been 

transferred with “Logo Transfer Software”.

You can set the auto setup function.

Set it to [AUTO] normally.

1)  Press ▲▼ to select [AUTO SETUP 

2)  Press ◀▶ to switch [AUTO SETUP 

▶

z

The setting will change as follows each time 

you press the button.

Enables the auto setup function 

when the projected signals are 

switched to the computer signals.

Enables the auto setup function 

only when the <AUTO SETUP> 

button is pressed.(



 page 40)

 

z

This setting is enabled only when computer or 

HDMI signal is input.

When the power is turned on, this function 

automatically detects the terminal to which signals are 

input and sets the function to switch.

1)  Press ▲▼ to select [SIGNAL 

2)  Press ◀▶ to switch [SIGNAL 

▶

z

The setting will change as follows each time 

you press the button.

Enables input detection.

Disables input detection.

 

z

If [ON] is set and you press the <AUTO SETUP> 

button on the remote control when the selected 

input is no signal, the terminal to which a signal is 

input is automatically detected and switched.