Manualsbrain.com
  1. Manuals
  2. Brands
  3. Panasonic
  4. PT-DZ770E
  5. Operating Guide

Panasonic PT-DZ770E Operating Guide

Download
Page of 124
[PROJECTOR SETUP] menu
68 - ENGLISH
Settings
[LAMP RELAY]
The lamp to be turned on can be automatically 
switched by specifying the day of the week and time.
The degradation of the lamp due to continuous usage 
can be reduced by automatically switching the lamp 
to be turned on when using the projector continuously 
for 1 week or more.
1)  Press ▲▼ to select [LAMP RELAY].
2)  Press ◀▶ to switch [LAMP RELAY].
▶
z
The time setting to switch the lamp will change 
as follows each time you press the button.
[OFF]
[24H]
[1WEEK]
3)  Press ▲▼ to select [TIME].
4)  Press the <ENTER> button.
▶
z
Enters adjustment mode (the display is 
blinking).
5)  Press ◀▶ to select [HOUR] or 
[MINUTE], and then press ▲▼ to 
adjust it.
(1 hour or 1 minute increments)
[00:00]
[00:01]
[00:59]
6)  Press the <ENTER> button.
▶
z
The adjusted time is established.
7)  Press ▲▼ to select [DAY OF THE 
WEEK].
8)  Press ◀▶ to switch [DAY OF THE 
WEEK].
▶
z
The setting will change as follows each time 
you press the button.
[SUNDAY]
[MONDAY]
[TUESDAY]
[WEDNESDAY]
[SATURDAY]
[FRIDAY]
[THURSDAY]
Note
 
z
The [LAMP RELAY] function is enabled when 
[DUAL] or [SINGLE] is selected in [LAMP SELECT].
 
z
The operating time will be the local time.(
 page 73)
 
z
Use the number (<0> to <9>) buttons on the remote 
control to directly enter the time.
[LAMP POWER]
Switch lamp brightness according to the operating 
environment or purpose of the projector.
1)  Press ▲▼ to select [LAMP POWER].
2)  Press ◀▶ to switch [LAMP POWER].
▶
z
The setting will change as follows each time 
you press the button.
[NORMAL]
[ECO]
[NORMAL]
Set when high luminance is 
required.
[ECO]
Set when high luminance is not 
required.
Note
 
z
When [ECO] is set, the power consumption and 
operation sound can be reduced while the lamp life 
can be increased.
[STANDBY MODE]
Set the power consumption during the standby.
1)  Press ▲▼ to select [STANDBY MODE].
2)  Press ◀▶ to switch [STANDBY 
MODE].
▶
z
The setting will change as follows each time 
you press the button.
[NORMAL]
[ECO]
Note
 
z
When set to [ECO], network functions and <SERIAL 
OUT> terminal are not available during standby. 
Also, some RS-232C commands are not available. 
When set to [NORMAL], network functions and 
<SERIAL OUT> terminal are available during 
standby.
 
z
When set to [ECO], display may delay about 10 
seconds when the power is turned on, compared to 
the [NORMAL] setting.