Panasonic CZTAW1 Operating Guide

7

 

■

When you cannot connect in the Wireless 

mode 

→ Check the strength of the wireless 

signal.

How to check the strength of the wireless signal (press the Check switch)

→You can check the strength of the wireless signal by checking if the 

Link LED is lighting or blinking. 

<

Wireless signal>

Strength: GOOD

Strength: NORMAL

Strength: BAD

Strength: IMPOSSIBLE

When there is no problem with the wireless signal but the Status 

LED does not light

→ Check the router connections.

* If the wireless signal strength is BAD or worse, connect using the 

Ethernet mode.

 

■

When you cannot connect in the Ethernet mode

 •When the Status LED does not light

→Check the LAN cable connections. 

Check the router connections.

 

■

When you want to set the IP of the wired LAN manually

1) Start the IP setting tool on the attached CD‑ROM and save the settings 

to a USB memory device.

2) Attach the USB memory device with the saved settings to the adaptor 

and press and hold the WPS switch for 10 seconds.

3) The Link LED lights when the settings are complete.

 

■

When you want to set the SSID of the wireless LAN manually

1) Start the SSID setting tool on the attached CD‑ROM and save the 

settings to a USB memory device.

2) Detach the USB memory device and then attach to the adaptor and 

press and hold the WPS switch for 10 seconds.

3) The Link LED lights when the settings are complete.

Link LED

Check switch

Register/Reset switch
Check switch

WPS switch

To switch WPS ON

Press the WPS 

switch.

This is only effective when 

Wireless mode is on.

To register a user

Press the Register/

Reset switch.

This is only effective when 

communications have been 

established.

To check the status of 

communications

Press the Check 

switch.

LEDs are displayed according 

to the connection status.

To switch between the 

Ethernet and Wireless 

modes

Press the Check 

switch for at least 

10 seconds.

The settings for each mode 

are maintained even if you 

change the mode.

To reset the software Press the Register/

Reset switch for at 

least 10 seconds.

This starts the process for 

the software to reset itself. 

When resetting, checks are 

made for the latest firmware, 

and this is updated if a new 

version is available.

To specify the SSID 

manually. 

(in Wireless mode) 

To specify the IP 

manually. 

(in Ethernet mode)

Press the WPS 

switch for at least 

10 seconds.

Connection is by WPS/

DHCP if there are no 

settings to load from the 

USB memory device.

To initialize the adaptor Simultaneously 

press the WPS 

switch and the 

Check switch for at 

least 10 seconds.

This restores the adaptor’s 

settings to the factory defaults.