Panasonic KXFC195GRG Operating Guide

Page of 82
9. Help
63
L
The ink film is slack or creased. Tighten it 
(see step 5 on page 13).
DIRECTORY FULL
L
There is no space to store new entries in 
navigator directory. Erase unnecessary 
entries (page 30).
FAX IN MEMORY
L
The unit has a document in memory. See the 
other displayed message instructions to print 
out the document.
FAX MEMORY FULL
L
The memory is full of received documents 
due to a lack of recording paper or a 
recording paper jam. Install paper (page 15) 
or clear the jammed paper (page 67).
L
When performing memory transmission, the 
document being stored exceeded the 
memory capacity of the unit. Transmit the 
entire document manually.
HANG UP HANDSET
L
Handset(s) is not hung up. Press {ih} on 
the handset(s).
MEMORY FULL
L
When making a copy, the document being 
stored exceeded the memory capacity of the 
unit. Press {STOP} to clear the message. 
Divide the document into sections.
MESSAGE FULL
L
There is no room left in memory to record 
voice messages. Erase unnecessary 
messages (page 42, 46).
MODEM ERROR
L
There is something wrong with the modem 
circuit. Contact our service personnel.
NO FAX REPLY
L
The other party’s fax machine is busy or has 
run out of recording paper. Try again.
PAPER JAMMED
L
A recording paper jam occurred. Clear the 
jammed paper (page 67).
PLEASE WAIT
L
The unit is checking that there is no slack or 
crease on the ink film. Wait for a moment 
while the check is completed.
POLLING ERROR
L
The other party’s fax machine does not offer 
the polling function. Check with the other 
party.
REDIAL TIME OUT
L
The other party’s fax machine is busy or has 
run out of recording paper. Try again.
REMOVE DOCUMENT
L
The document is jammed. Remove the 
jammed document (page 69).
SEND CANCELLED
L
You pressed {C} while the unit was in redial 
mode for fax transmission. The redialling was 
cancelled.
TRANSMIT ERROR
L
A transmission error occurred. Try again.
UNIT OVERHEATED
L
The unit is too hot. Let the unit cool down.
Frequently Asked Questions
9.3 When a function does 
not work, check here
If you still have difficulties after following the 
instructions in this section, reset the unit. 
Disconnect the power cord and turn off the 
handset. Remove the batteries, then re-insert 
them. Reconnect the power cord and turn on the 
handset.
9.3.1 General
I cannot make and receive calls.
L
The power cord or telephone line cord is not 
connected. Check the connections.
L
If you used a splitter to connect the unit, 
remove the splitter and connect the unit to the 
wall jack directly. If the unit operates properly, 
check the splitter.
I cannot make calls.
L
The dialling mode setting may be wrong. 
Change the setting both on the base unit 
FC195GR.book  Page 63  Wednesday, April 2, 2003  11:39 AM