Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY Specification Guide

Installing and Upgrading Internal Modules in Cisco 2800 Series Routers

OL-5792-04

Installing the Chassis Cover

Installing the Cover on Cisco 2811 Routers

To install the chassis cover on a Cisco 2811 router, follow these steps. A number 2 Phillips screwdriver
is required.

Step 1

Position the cover so that it rests flat on the chassis, with the front (bezel) end of the cover about 1 inch
(25 mm) from the front end of the chassis. See

Figure 51

Figure 51

Cover in Position for Installation

Step 2

Slide the cover toward the front so that the fingers enter the slots and the cover is fully closed. Press the
cover flat against the chassis while you slide the cover closed.

Step 3

Use a Phillips’ screwdriver to install the four screws at the top rear of the cover.

103528

Plastic bezel

Chassis

Cover

Approx. 1 inch
(25 mm)