Cisco 7500 SERIES ROUTE SWITCH PROCESSOR 16 Specification Guide

After the system boots the software and initializes the interface processors, verify that the RSP16 LEDs
are in the following states:

RSP16 normal LED is on (for each RSP16 installed).

CPU halt LED is off (for each RSP16 installed).

Active RSP16 active LED is on (if HSA or HA is configured).

Standby RSP16 standby LED is on (if HSA or HA is configured).

Boot time is approximately 1 minute for systems with one RSP16 and approximately 1.5 minutes for
systems with two RSP16s. These times vary with system configuration and with the source location of
the image being booted.

Verify that all the enabled LEDs (on the interface processors) are on.

In systems with a second RSP16 installed (and HSA or HA configured), use the show version command
to verify that the standby RSP16 is recognized by the system. Following is a sample from a Cisco 7513:

Router> show version

Cisco Internetwork Operating System Software

IOS (tm) RSP Software (RSP-JSV-M), Version 11.1 [biff 51096]

Copyright (c) 1986-1999 by cisco Systems, Inc.

Compiled Mon 22-Sep-99 21:15 by biff

Image text-base: 0x600108A0, data-base: 0x607B8000

[additional displayed text omitted from this example]

Slave in slot 7 is running Cisco Internetwork Operating System Software

(Note that this could also be “slot 6,” depending on which RSP is configured as the standby or the recent
crash history of your router.)

When you have verified all the conditions in

through

(or

if you have a second RSP16

installed and want to use the HSA or HA features), the installation is complete. If you replaced the
RSP16 and saved your configuration file to a remote server before doing so, see the

. If you replaced the RSP16 and did not save the configuration,

use the configure command or the setup facility to reenter the configuration information.

An error condition exists if no LEDs go on at power up or after initialization, or if the boot error or CPU
halt LEDs go on and remain on. If this happens, proceed to the

 to try to isolate the problem.

For more complete configuration information, refer to the Configuration Fundamentals Configuration
Guide and the Configuration Fundamentals Command Reference publications, which are available
online, on the Documentation CD-ROM, or as printed documents.

If you have a second RSP16 installed, you must configure the HSA (or HA, if you prefer) features for
your Cisco 7507, Cisco 7507-MX, Cisco 7513, or Cisco 7513-MX router. Read the following caution,
and then proceed to either the

, or the

.