Cisco CATALYST 5500 9 PORT GIGABIT ETHERNET SWITCH MODULE Specification Guide
Switching Module Installation 3-21
Connecting ATM LANE Modules
Step 5
Connect an interface cable between the PHY B port on the station (FDDI
module) side of the bypass switch and the FDDI module PHY B port.
module) side of the bypass switch and the FDDI module PHY B port.
Step 6
Connect the bypass switch control cable. If the control cable on your optical
bypass switch uses a mini-DIN connector, connect the cable directly to the
mini-DIN optical bypass port on the FDDI module.
bypass switch uses a mini-DIN connector, connect the cable directly to the
mini-DIN optical bypass port on the FDDI module.
Connecting ATM LANE Modules
The physical layer interface module (PLIM) on the ATM LANE module determines the
type of ATM connection. There are no restrictions on slot locations or sequence; you can
install an ATM fiber-optic module in any available module slot.
type of ATM connection. There are no restrictions on slot locations or sequence; you can
install an ATM fiber-optic module in any available module slot.
You need a SC-type single-mode (fiber) connector for SMF or MMF connections, shown
in Figure 3-15, to connect the ATM LANE multimode switching module with an ATM
switch.
in Figure 3-15, to connect the ATM LANE multimode switching module with an ATM
switch.
Figure 3-15
Network Interface Connector (SC Type)
Connect the ATM interface cables to the appropriate ATM network connector, as shown in
Figure 3-16.
Figure 3-16.
H2214