ONKYO TX-NR777 Owner's Manual

Initial Setup with Auto Start-up Wizard

When you turn the unit on for the first time after purchasing 
it, Initial Setup is automatically shown on the TV to enable 
you to make settings required for startup using simple 
operations following onscreen guidance.
1. Switch the input on the TV to that assigned to the unit.
2. Put batteries into the remote controller of this unit.
3. Press Í on the remote controller to turn the unit on.
4. Select the item with the cursors of the remote controller 

and press ENTER (a) to confirm your selection. To return 
to the previous screen, press 

 (b).

0 If you terminate the procedure on the way or want to 

change a setting made during Initial Setup, press 

 on 

the remote controller, select "7. Miscellaneous" – "Initial 
Setup", and press ENTER.

∫ 1. AccuEQ Room Calibration

Place the supplied speaker setup microphone in the listening position, 
measure the test tones emitted by the speakers, then the unit 
automatically sets the optimum volume level for each speaker, the 
crossover frequencies, and the distance from the listening position. This 
also automatically adjusts the equalizers for the speakers and enables 
correction of distortion caused by the acoustic environment of the room.

0 Calibration takes between 3 and 12 minutes to be 

completed. The speakers emit the test tone at high volume 
during measurement, so be careful of your surroundings. 

Troubleshooting | Supplementary Information, etc.

TV

a

b