ONKYO PR-RZ5100 Owner's Manual

> Before start > Hookup

> Playback > Part Names

Troubleshooting | Appendix

Step7: Power On & Initial Setup

Initial Setup starts automatically
Switch the input on the TV to that assigned to the unit.
When you turn the unit on for the first time, Initial Setup is 
automatically shown on the TV to enable you to make 
settings required for startup using simple operations 
following onscreen guidance.

0 If you terminate the procedure on the way or want to 

change a setting made during Initial Setup, press 

 on 

the remote controller, select "7. Miscellaneous" – "Initial 
Setup", and press ENTER.

: Selection

: OK

: Return

Place the supplied speaker setup microphone in the 
listening position, measure the test tones emitted by the 
speakers, then the unit automatically sets the optimum 
volume level for each speaker, the crossover frequencies, 
and the distance from the listening position. This also 
enables correction of distortion caused by the acoustic 
environment of the room.

0 When putting the speaker setup microphone on a tripod, 

refer to the illustration when putting it in place.

0 Set the subwoofer volume to more than halfway.
0 Calibration takes between 3 and 12 minutes to be 

completed. The speakers emit the test tone at high 
volume during measurement, so be careful of your 
surroundings. Keep the room as quiet as possible during 
measurement.

0 When using THX certified speakers, THX recommends 

setting the crossover frequency to "80Hz(THX)". It is also 
recommended to manually adjust the settings for each 
speaker to suit the specific characteristics of each room.

Setup

SETUP MIC