ONKYO PR-RZ5100 Owner's Manual

Troubleshooting | Appendix

■ Tuning Automatically

1.  Press TUNER on the remote controller several times to 

select either "AM" or "FM".

2.  Press MODE on the remote controller so that 

"TunMode:Auto" appears on the display.  

3.  Press the cursors  /  on the remote controller to start 

automatic tuning.

•  Searching automatically stops when a station is 

found. When tuned into a radio station, the "TUNED" 

indicator on the display lights. When tuned into an 

FM radio station, the "FM ST" indicator lights.

•  No sound is output while the "TUNED" indicator is 

off.

When FM broadcasts reception is poor:

Radio waves may be weak depending on the building 

structure and environmental conditions. In that case, 

perform the procedure as explained below in "Tuning 

Manually" to manually select the desired station.

■ Tuning Manually

1.  Press TUNER on the remote controller several times to 

select either "AM" or "FM".

2.  Press MODE on the remote controller so that 

"TunMode:Manual" appears on the display.

3.  While pressing the cursors  /  on the remote 

controller, select the desired radio station.

•  The frequency changes by 1 step each time 

you press the button. The frequency changes 

continuously if the button is held down and stops 

when the button is released. Tune by looking at the 

display.

To return to the auto tuning mode:

Press MODE on the remote controller again so that 

"TunMode:Auto" appears on the display. The unit tunes 

automatically into a radio station.

■ Tuning to the frequency directly

It allows you to directly enter the frequency of the radio 

station you want to listen to.
1.  Press TUNER on the remote controller several times to 

select either "AM" or "FM".

2.  Press D.TUN on the remote controller.

3.  Using the number buttons on the remote controller, 

enter the frequency of the radio station within 8 

seconds.

•  To enter 87.5 (FM), for example, press 8, 7, 5, or 

8, 7, 5, 0. If you entered the wrong number, press 

D.TUN and enter the correct one.

It allows you to register up to 40 of your favorite AM/FM 

radio stations. Registering radio stations in advance allows 

you to tune into your radio station of choice directly.

■ Registration Procedure

1.  Tune into the AM/FM radio station you want to register.
2.  Press MEMORY on the remote controller so that the 

preset number on the display flashes.

3.  While the preset number is flashing (about 8 seconds), 

repeatedly press the cursors  /  on the remote 

controller to select a number between 1 and 40.

4.  Press MEMORY on the remote controller again to 

register the station.

•  When the station is registered, the preset number 

stops flashing.

•  Repeat this procedure for all of your favorite AM/FM 

radio stations.

■ Selecting a Preset Radio Station

1.  Press TUNER on the remote controller.
2.  Press the cursors  /  on the remote controller to 

select a preset number.

■ Deleting a Preset Radio Station

1.  Press TUNER on the remote controller.
2.  Press the cursors  /  on the remote controller to 

select the preset number to delete.

•  You can also select by directly entering the preset 

number with the number buttons on the remote 

controller.

3.  After pressing MEMORY on the remote controller, press 

CLR while the preset number is flashing to delete the 

preset number.

•  When deleted, the number on the display goes off.