Petsafe Train n' Praise™ Treat Dispenser Owner's Manual

6 

Customer Care Center 1-800-732-2677

Step 1

1. Using a small flathead screwdriver (or equivalent), place into the slot on the bottom and 

turn until the top and bottom release (1A).

2. Install one (1), 3-volt (CR2032) battery under the clip, positive (+) side up (1B).
3. Firmly press the top and bottom back together (1C). 

Replacement batteries (3-volt, CR2032) can be found at many retailers. Contact the 
Customer Care Center or visit our website at www.petsafe.net for a list of common retailers.

Risk of explosion if batteries are replaced by an incorrect type. Do not 
short circuit, mix old and new batteries, dispose of in fire, or expose to 
water. When batteries are stored or disposed, they must be protected 
from shorting. Dispose of used batteries properly.

Step 2

1.  Remove the battery compartment door (2A).
2.  Install four (4) AA batteries into the battery 

compartment on the back of the Treat Dispenser (2B). 

3.  Replace the battery compartment door.

Risk of explosion if batteries are 
replaced by an incorrect type. Do 
not short circuit, mix old and new 
batteries, dispose of in fire, or 
expose to water. When batteries 
are stored or disposed, they 
must be protected from shorting. 
Dispose of used batteries properly.