Petsafe Train n' Praise™ Treat Dispenser Owner's Manual

8 

Customer Care Center 1-800-732-2677

Treat Dispenser is turned on

Battery status LEDs flash for 3 seconds

Treat Dispenser is on and idle

No LEDs or flashing

Treat Dispenser is on with low battery

3 Red LEDs flash 3 times every 10 seconds

Signal from Handheld Remote is received 3 Orange LEDs flash once

Pairing Mode

3 Green LEDs flash once every second

Pairing successful

3 Orange LEDs flash once

Step 3

The Handheld Remote and Treat Dispenser are paired from the factory. If you installed the 
batteries properly and the Treat Dispenser is not responding to the Handheld Remote, follow 
these steps:
1. Turn the Treat Dispenser on by pressing and holding down the power button for 4 

seconds. The green LED will flash once every second indicating that the Treat Dispenser 
is in pairing mode.

2. While standing at least 3 feet away, push and release the Handheld Remote button once.
3. If the Remote ID is not already stored in memory, the Treat Dispenser LEDs will flash 

orange and emit a confirmation tone (if the audible tone is enabled). Exit pairing mode by 
pressing the power button once, or wait 30 seconds. If pairing was successful, the Treat 
Dispenser LEDs will flash orange for confirmation.

4. To test the pairing, push and release the Handheld Remote button once. If paired 

correctly, the Treat Dispenser will dispense treats/kibble (if filled).

5. If the Handheld Remote is still not pairing, please contact the Customer Care Center.