Petsafe Train n' Praise™ Treat Dispenser Owner's Manual

www.petsafe.net

4. Open the Hopper lid on the Treat Dispenser to size the

treats/kibble before ﬁlling. This Treat Dispenser requires
dry treats or kibble that can ﬁt through the dispenser.
Round or oval kibble of uniform size and shape work
best, 1/2" size or smaller. The treat/kibble size indicator is
located inside the Hopper lid (2C).

For dry treats/kibble up to 1/2" size or
smaller only.

5. Remove the Hopper by pressing the Hopper button. Locate

the ramp in the treat compartment. Move the ramp to
correspond to the measured treat size. If
the kibble ﬁts into the cup labeled 1, the
ramp needs to be in the lower position
(2D). In this position you should be able
to see the upper setting hole. If the
kibble is larger and ﬁts into cup 2, then
the ramp must be snapped into the
upper position (2E). The ramp will be set
by default from the factory in the lower
position for #1 size treats.

6. Once the treat/kibble size and ramp

height have been determined, ﬁll the Hopper to the ﬁll line (2F) and
close the hopper lid.

7. Press and release the power button on front of the Dispenser to

turn the Dispenser on. The LED’s will light to indicate it is on and
will display the battery status (see Battery Status Indicator below).

8. The audible tone is on from the factory. Turn the tone switch off (on

back of Dispenser) if you prefer to train without it.

9. Press the button on the Handheld Remote to dispense the dry treats/kibble.
10. To turn the Treat Dispenser off, press and hold the power button.

The Red LED will appear until the Dispenser powers off.

Battery Status Indicator

When turning on the Treat Dispenser, the LED surrounding the on/off button will indicate the
battery status in the following manner:

70-100% Battery
3 Green LEDs appear for 3
seconds

40-70% Battery
2 Green LEDs appear for 3
seconds

10-40% Battery
1 Green LEDs appear for 3
seconds

1-10% Battery
3 Red LEDs appear for 1 second
then ﬂash for 2 seconds