Rommelsbacher CT 2215/IN User Manual

25

•  By touching the “+“ sensor (4) you can 
  increase  the operating time in minute 
  intervals up to 99 minutes.
•  By touching the “-“ sensor (5) you can re-
  duce the operating time in minute inter-
  vals. 
•  By continuously pressing the “+“ sensor 
  (3) or “-“ sensor (5) you can increase or 
  reduce the operating time in 5-minute 
  intervals.

•  Once the set time has elapsed there is an 
  audible signal and the control automati-
  cally switches over to standby mode.

NOTE: Changing the power or temperature level will not affect the set operating time. 

•  For switching-off touch the main switch 
  sensor (1). 
•  The display “temp“ (7b) shows “-L-“ or 
  “-H-“, depending on the residual heat on 
  the cooking zone. Also an audible signal 
  sounds. Now the control is in standby 
  mode.

NOTE: If the waste heat of the pot creates a temperature on the cooking zone of more than 50 °C 
the display “temp” (7b) shows “-H-“ for HOT. As soon as the temperature has sunk below 50 °C, 
the display “temp” (7b) shows “-L-“ for LOW. 
When the unit is disconnected from the mains the display “temp” (7b) expires.

NOTE: It is normal for the fan to continue running in the standby mode after a long operation time. 

Before cleaning always disconnect the unit from the mains! 
Let the appliance cool down before cleaning!
 

 

•  Remove any coarse residues from the glass ceramic plate by means of a special glass scraper, 

which is available in the specialised trade and in household equipment shops.

•  Following that clean the cold glass surface with a damp cloth and some dishwater and wipe it 

dry with a clean cloth or kitchen tissue. On the market there are suitable cleaning agents for 
glass ceramic cooktops available with which the whole glass surface is treated by means of a 
kitchen tissue until there is no soiling visible anymore. 

•  Never immerse the appliance into water and do not use steam jet appliances.