Driven Designs Inc. PPS User Manual
Page 14
POOL PATROL PA-25 & PA-30
the mode button down while turning on the receiver. Once the receiver is
turned on, release the mode button. The unit has now changed modes.
turned on, release the mode button. The unit has now changed modes.
SN mode
In this mode the receiver will accept any Pool Patrol transmitter.
In this mode the receiver will accept any Pool Patrol transmitter.
ID mode
In this mode the receiver will only accept the transmissions from only
those ID codes the receiver has learned. It locks out all other
transmitters.
In this mode the receiver will only accept the transmissions from only
those ID codes the receiver has learned. It locks out all other
transmitters.
Learn Mode
With the receiver in ID mode,
pushing and releasing the
mode button once will put the
receiver in learn mode causing
the LED on the front of the
receiver to turn green. Learn
mode will timeout after 18
seconds and the receiver will
go back to normal operation
causing the LED will go back
to red. Once in learn mode the
receiver is waiting for the ID
code
With the receiver in ID mode,
pushing and releasing the
mode button once will put the
receiver in learn mode causing
the LED on the front of the
receiver to turn green. Learn
mode will timeout after 18
seconds and the receiver will
go back to normal operation
causing the LED will go back
to red. Once in learn mode the
receiver is waiting for the ID
code
from
a
transmitter.
Trigger the transmitter and
send the serial number and ID
number to the receiver. To
trigger the transmitter connect the ring and post with a paper clip or piece
of wire.
send the serial number and ID
number to the receiver. To
trigger the transmitter connect the ring and post with a paper clip or piece
of wire.
The receiver will take the ID number and store it in memory. Up to 8
transmitters can be learned by each receiver. If the receiver accepts the
ID code from the transmitter the green LED will turn off and on and then
turn red and blink rapidly.
transmitters can be learned by each receiver. If the receiver accepts the
ID code from the transmitter the green LED will turn off and on and then
turn red and blink rapidly.
Erasing Memory
Place the receiver in ID mode. Holding the mode button in for 10
seconds will erase the receiver memory. All of the transmitter ID
numbers stored in memory will be cleared. Once the mode button is
pressed the LED will turn green for 10 seconds. When the LED turns off
the memory is erased. After releasing the mode button the LED will
Place the receiver in ID mode. Holding the mode button in for 10
seconds will erase the receiver memory. All of the transmitter ID
numbers stored in memory will be cleared. Once the mode button is
pressed the LED will turn green for 10 seconds. When the LED turns off
the memory is erased. After releasing the mode button the LED will
Figure 10 Mode Button
Mode
Button
Button